Eurocave Inoa 25 Mode D'emploi page 19

7/ COMMISSIONING YOUR CONDITIONER
I. Connection
Check that the plug is connected to a power supply (presence of correct amp fuses, functioning 30 mA* differential circuit breaker - not applicable to certain countries).
Wait 48 hours before plugging in your conditioner.
II. Switching on
- Place the switch, located under the conditioner, in position 1.
- Press and hold down the key on your remote control for about 8 seconds, until the indicator goes off.
To put your conditioner on standby, press and hold down the key on your remote control for about 5 seconds and release it before the indicator goes off.
III. Remote control description
Radio frequency remote control (433.92 Mhz).
Each remote control has a personalised code matched to the conditioner.
9
GB