emerio FH-124260.1 Mode D'emploi page 8

Operation
Plug the appliance into an appropriate electrical outlet. Turn on the appliance by pressing the main power
switch to position "I". A beep sound will be heard at the meantime.
Press the ON/OFF button on the control panel or remote control, the appliance begins to work on fan mode.
The on/off indicator light will be on and the display will show the room temperature.
Note:
(1) Some parts of this product can become very hot and cause burns. Do not use it in areas where gasoline,
paint, or any flammable liquids are used or stored.
(2) The heater is designed to be used at temperatures above -20℃.
(3) There may be a trace of odour during the first few minutes of initial use, or after a period of storage. This
is normal and will quickly disappear.
1. Power setting
(1) "Mode" button on the remote control:
Press the button to select your desired power setting: Fan; Low heat (01); High heat (02). The corresponding
indicator light will be on.
(2) "Mode/On/off" button on the control panel:
Press the "Mode/On/off" button to select the power setting: fan → low heat → high heat → shutdown → fan
→ .... The corresponding indicator light will be on.
If you press the "Mode/On/off" button to shut down the appliance, the fan indicator light will be flashing, the
on/off indicator light will be off and the appliance will be off after about 30 seconds.
2. Temperature setting
Press the button "-" or "+" on the remote control or "Tem." on the control panel to set the desired
temperature. You can choose from 15℃ to 40℃. When you set your desired temperature, it will flash a few
seconds, and then shows the room temperature again.
When the set temperature is 4℃ or more higher than the room temperature, the appliance will work on high
heat;
When the set temperature is 2-3℃ higher than the room temperature, the appliance will work on low heat;
When the room temperature reaches the set temperature, the appliance will switch to fan mode automatically.
Note:
(1) The power setting and temerperature seting cannot coexist; the appliance will run according to the the
lastest setting.
(2) During use, if there is no operation within five minutes, the display and indicator lights will be off. Press
any button to activate the appliance.
3. Timer setting
Press the button "Timer" to set your desired working time from 00 (off) → 01 (1h) → 02 (2h) → ... → 12 (12h)
→ 00 (off) → .... The timer indicator light will be on. When the set time has elapsed, the appliance will be off
and under standby condition.
4. Oscillation
Press the button "Swing", the appliance begins to swing in horizontal direction. The swing indicator will be on.
Press the button again, the oscillation will stop.
- 7 -