GreenWorks GD60CS40 Manuel Opérateur page 10

7 TROUBLESHOOTING
Problem Possible cause
The guide bar The chain is too
and the chain tight.
become hot and
The oil tank is
release smoke.
empty.
Contamination
causes a block-
age of the dis-
charge port.
Contamination
causes a block-
age of the oil
tank.
Contamination
causes a block-
age of the guide
bar and the oil
tank cap.
Contamination
causes a block-
age of the
sprocket or
guide wheels.
The motor runs The chain is too
but the chain tight.
does not rotate.
The guide bar
and the chain
are damaged.
English
Problem
Solution
Adjust the chain
tension.
Add lubricants.
Remove the
guide bar and
clean the dis-
charge port.
Clean the oil
tank. Add new
lubricant.
Clean the guide
bar and the oil
tank cap.
Clean the
sprocket and the
guide wheels.
The motor runs
and the chain ro-
tates, but the
chain does not
Adjust the chain
cut.
tension.
Replace the
guide bar and
the chain if it is
necessary.
The machine
does not start.
9
Possible cause Solution
1. Remove the
battery pack
from the ma-
chine.
2. Remove the
guide bar
cover.
3. Remove the
bar and saw
chain.
4. Clean the
The motor is
machine.
damaged.
5. Install battery
pack and op-
erate the ma-
chine.
If the sprocket
rotates, it means
the motor works
properly. If not,
call service cen-
ter.
Sharpen or re-
The chain is
place the saw
blunt.
chain.
The chain is in Turn the chain
the incorrect di- loop to the other
rection. direction.
The chain is tight Adjust the chain
or loose. tension.
Pull the chain
brake in the di-
The chain brake
rection of the
is engaged.
user to disen-
gage it.
Make sure that
The machine the battery re-
and battery are lease button
not connected clicks when you
correctly. install the battery
pack.
The battery level Charge the bat-
is low. tery pack.
1. Push the
lock-out but-
The lock out but-
ton and hold
ton and the trig-
it.
ger are not push-
ed at the same
2. Push the trig-
time.
ger to start
the machine.
EN