tomado TMF1101B Mode D'emploi page 11

Check that the voltage corresponds with what is stated on the information plate. Insert the plug in the socket.
Place the attachment (with spring) at the bottom of the milk jug onto the drive shaft. Fill the milk frother with the required
amount of milk. Take note of the lower maximum indication for frothing milk - MAX
the milk frother could overflow when using too much milk. The minimum capacity is 75 ml.
Making hot milk froth
Place the cover and place the milk frother on the power base. Switch the ON/OFF button to I. The indicator LED will light up and
the milk frother will start working. Depending on the amount of milk, the milk frother stops automatically after approximately
90 seconds. The indicator LED will swicth off and the milk frother is ready.
When the milk frother is ready, remove the cover and pour the milk froth in a mug or cup. Do not use a spoon or other metal
object to scoop out the milk froth. This will damage the coating.
After use, the milk frother should be cleaned as described in chapter CLEANING & MAINTENANCE.
If the milk is not or not completly poured, the milk frother will automatically restart when it has cooled down below 50C.
After use switch the ON/OFF button to 0 and remove the plug from the wall socket.
BOIL-DRY PROTECTION
If there isn't sufficient milk in the milk frother, it will shut OFF automatically. Nevertheless, always ensure that there is enough
milk in the product, as switching the device OFF automatically can shorten its life span.
Allow the product to cool down before filling it again.
TIPS
• You will get the best milk froth result with full-cream milk.
• If there is too little milk in the milk frother (less than 75 ml), the result will be less good.
• The quality of the milk froth can differ significantly between different brands of milk. Experiment with other brands,
if necessary, for a better result.
Remove the plug from the wall socket and allow the milk frother to cool prior to cleaning.
Clean the milk frother after each use.
Never submerge the milk frother and power base in water and/or any other liquid. Also do not rinse it under the tap.
Regularly wipe the outside with a moist cloth.
Remove the whisk or mixer from the milk frother by lifting it straight upwards. Pour some hot water in the milk frother
to remove all milk residues. If necessary, use a drop of washing-up liquid to remove the fatty film left by the milk. Then wipe
clean the inside of the milk frother with a soft cloth or some kitchen paper to prevent the coating from getting damaged.
Make sure there are no more milk residues in the milk frother. This is unhygienic and could be harmful to your health. Clean
the cover, silicone ring of the cover, whisk and mixer with warm water and a mild washing-up liquid. Dry these components
thoroughly.
Never use detergents and/or abrasives or sharp objects that could damage the coating!
This symbol means that this product should not be disposed of with regular household waste (2012/19/EU).
Observe the applicable rules in your country for the separate collection of electric and electronic products.
By disposing of the product correctly, you prevent negative consequences for the environment and for public health.
The packaging material of this product can be recycled 100%, return packaging material separately.
FROTHING MILK
CLEANING AND MAINTENANCE
RECYCLING
EN - 11
- 185 ml. Frothing milk expands and