Before using the appliance for the first time, please proceed as follows: carefully remove the milk frother from its packaging and
remove all the packaging material. Keep the packaging (plastic bags and cardboard) out of the reach of children. After unpacking
the appliance, check it for external damage that may have occurred during transport. Place the milk frother on a heat-resistant
flat surface.
Clean the cover, attachment and spring with warm water and a mild washing-up liquid. Dry these components thoroughly.
Only clean the base unit and interior with a moist cloth and dry thoroughly. The milk frother is only suitable for frothing
and heating milk. Never fill the milk frother with other liquids.
Check that the voltage corresponds with what is stated on the information plate. Insert the plug in the socket.
Place the attachment (without spring) at the bottom of the milk jug onto the drive shaft. Fill the milk frother with the required
amount of milk. Take note of the upper maximum indication for only heating milk - MAX
Place the cover and place the milk frother on the power base. Switch the ON/OFF button to I. The indicator LED will light up and
the milk frother will start working.
Depending on the amount of milk, the milk frother stops automatically after approximately 90 seconds. The indicator LED will
swicth off and the milk frother is ready.
When the milk frother is ready, remove the cover and pour the hot milk in a mug or cup.
After use, the milk frother should be cleaned as described in chapter CLEANING & MAINTENANCE.
If the milk is not or not completly poured, the milk frother will automatically restart when it has cooled down below 500C.
After use switch the ON/OFF button to 0 and remove the plug from the wall socket
PRODUCT DESCRIPTION
1. Cover with silicone ring
1
2. On / Off button
3. Power base
4. Maximum indication for heating - MAX
5. Maximum indication for frothing - MAX
6. Attachment for warming and frothing
2
3
PRIOR TO FIRST USE
HEATING MILK
EN - 10
4
5
6
- 300 ml.