Metabo SSEP 18 LTX BL MVT Notice Originale page 11

Masquer les pouces

page de 72

/ 72
Signets

Les langues disponibles

Occasionally shift the guide (2) to achieve even

wear of the saw blade.

1. Swivel the lever (1) downwards and shift the

guide (2) to the desired position. See image

series B

2. Swivel the lever (1) upwards and turn the guide

(2), if needed, until the lever engages again.

Check the guide (2) to ensure that it is securely

fitted. It has to be engaged.

7. Use

7.1

Setting speed

Set the recommended speed using the thumbwheel

(8). (Lower number = lower speed; higher number =

higher speed)

7.2

Switching on and off, stroke rate,

Switch-on lock (9):

Trigger (10) locked.

Trigger (10) unlocked.

Switching on, speed: press the trigger switch (10).

The stroke rate can be changed by pressing in the

trigger.

Switching off: Let go of the trigger switch (10) .

7.3

Stepless stroke rate setting

The stroke rate can be changed steplessly by

varying the pressure applied to the trigger switch

(9), thus adapting it to the material and working

conditions.

7.4

Working Directions

Sawing:

Use a saw blade geared to the material to be sawn.

Press the machine with the guide (2) against the

workpiece. Switch on the machine, and only then

guide the saw blade against the workpiece.

Do not make contact with any objects or with the

ground with the moving saw blade (risk of recoil or

of breaking the saw blade).

Adapt the stroke rate to the material to the sawn.

Avoid excessive pressure on the saw blade

(particularly in the case of long saw blades).

If the saw blade jams, turn the machine off

immediately. Widen the sawn gap slightly with a

suitable tool and take out the machine.

After completing the sawing cut, switch off the

machine and only take it out of the sawn gap to

place it down once the saw blade has come to a

standstill (danger of recoil).

7.5

Activate and deactivate pendulum stroke

Activate pendulum stroke (16) for particularly high

cutting output by turning in clockwise direction until

the stop (pos. I) and deactivate by turning anti-

clockwise until the stop (pos. 0) (see fig. B S.2)

Plunge cuts:

Plunge cuts may only be made in soft materials

such as wood or plastic. Only use short saw blades.

Hold the machine with both hands at the intended

handles, take a secure stance and concentrate on

the work.

See illustration sequence D, page 2: The machine is

pressed with the edge of the guide (2) against the

workpiece. The saw blade does not make contact

with the workpiece. Switch on the machine. The

corner of the guide serves as a pivot point around

which the machine is slowly aligned, whereby the

saw blade cuts into the workpiece.

Scaffold hook

The scaffold hook (7) is intended to store the

tool.

8. Use

8.1

Switching on and off, stroke rate,

Switch-on lock (9):

Trigger (10) locked.

Trigger (10) unlocked.

Switching on, speed: press the trigger switch (10).

The stroke rate can be changed by pressing in the

trigger.

Switching off: Let go of the trigger switch (10) .

Continuous activation: With the trigger (10)

pressed, push in the locking button (8) and

release the trigger. Press and release the trigger

(10) again to switch off.

In continuous operation, the machine

continues running if it is forced out of your

hands. Therefore, always hold the machine with

both hands using the handles provided, stand

securely and concentrate.

8.2