Pioneer DEH-790 Mode D'emploi page 11

Using the Remote Control
Note:
Remote control is only available on DEH-790.
DEH-690 does not have remote control
function.
[18] Remote control sensor
[20] Transmitter
[21] Tuner
The tuner is selected. Pressing again turns
off the power.
[22] CD
When a disc is inserted in the built-in CD
player, the unit will switch to disc play
mode. Pushing the button once again turns
the power off.
[24] Volume
Press the (+) side to increase volume and
the (--) side to decrease volume.
[27] Learn Button
Takes. on the function of the button opera-
tion recorded with the learning function.
Refer to the "Learning Function" section for
details. -
[28] Attenuator
Press to reduce the volume to 1/10 of its
current setting (volume display flashes).
Pressing again returns the volume to its
original level.
* This function is available using the re-
mote controller unit only.
Operating the Tuner
[23] Preset Channel
Press to tune the frequencies assigned to
the preset button memory. Pressing the (+)
side tunes in the next high preset button
number, while (-) tunes in the next lower
preset button number. The preset number
changes at high speed when you hold ei-
ther side of this button down.
[25] Best Stations Memory
Hold on this button for about 2 seconds,
and you will hear a beep and see Best
Stations Memory start.
[26] Band
Band changes.
FIR Ie Ene tye
(FM1) (FM2) (FM3) = (MW/LW)
Operating the CD Player
[23] Track Number Search
Press to search for a selection (track num-
ber) on the current disc. Press the (+) side
to increase the track number on the display,
and the (-) side to reduce the track number.
Holding down either side of this button
changes the track number at high speed.
Learning Function
Records one button from the main unit on
the remote control's learn button. This can
be convenient when a button which is used
often is recorded.
1.While playing the CD, press button [10]
on the main unit for about 2 seconds, un-
til a beep is emitted. "LRN" will be dis-
played on the display.
* While the radio is on, the button can not
be recorded on to the remote control's
learn button.
2.Press the button on the main unit that
you want to use on the remote control.
3.Press the learn button [27] on the remote
controller unit. The main unit button
recorded can now be used from the re-
mote control.
* Perform button recording while "LRN" is
displayed. If about 5 seconds pass with-
out a button being recorded, the "LRN"
display will clear, and the previously
recorded button will remain in memory.
Preparing to Use the Remote
Controller Unit
Loading Batteries
1.Remove the battery compartment cover
from the remote controller unit.
2.Load 2 batteries, whose type is UM-4,
AAA, or R03, as applicable, that come
with the unit into the remote controller
unit, ensuring that their polarity (+/-) is
correct.
3.Replace the battery compartment cover.
— 7
NEE
Fig. 18