Publicité
Les langues disponibles
Les langues disponibles
overload current value (motor burn-up point). If continued overload
shutdowns occur, apply less force/weight on the tool until the tool
will function without the overload engaging.
COMPLETE ELECTRONIC CONTROL™
The internal electronic speed control offers consistent wheel speed
while using the tool.
Motor
Be sure your power supply agrees with the nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. D
WALT tools are factory tested; if this tool does not
E
operate, check power supply.
FIG. 1
C
I
A
N
This grinder is designed for professional grinder, sander, wire brush,
H
This grinder is a professional power tool. DO NOT let children come
E
The side handle (C) can be fitted to either side of
F
G
8
COMPONENTS (FIG. 1)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Spindle lock button
B. Spindle (not shown)
C. Side handle
D. 6" (150 mm) grinding wheel
(not shown)
E. Anti-lockup backing flange
INTENDED USE
polisher or cut-off application.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
into contact with the tool. Supervision is required when inexperienced
operators use this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury.
ATTACHING SIDE HANDLE (FIG. 2)
the gear case in the threaded holes, as shown.
Before using the tool, check that the handle is
tightened se cure ly. Use a wrench to firmly
tighten the side handle.
F. Threaded clamp nut
G. Guard
H. Dust ejection system
(DES)
I. Slider switch
FIG. 2
C
Publicité
