Holmatro GSP 52 EVO 3 Serie Mode D'emploi page 43

• Press the lock pin (A) at the bottom and the top.
• Remove the spreading tip (B).
• Push the pulling attachment (D) onto the spreading arm (C).
• Make sure the openings of the shortening hooks do not point down.
• Check that the pulling attachment is properly locked by the lock pin.
• Attach the pulling chain to the pulling attachment.
• Repeat the action for the second pulling attachment.
5.8.2 Attaching spreading tips
See Fig. 7.
Two spreading tips are delivered as a standard with the spreader. Spare spreading tips can be ordered
if desired.
To replace the default spreading tips by the spare spreading tips:
• Make sure that the spreading arms are slightly open.
• Press the lock pin (A) at the bottom and the top.
• Remove the spreading tip (B).
• Push the new spreading tip onto the spreading arm (C).
• Check that the spreading tip is properly locked by the lock pin.
• Repeat the action for the second spreading tip.
5.8.3 Attaching cutting tips
See Fig. 8.
Cutting tips make it possible to use the spreader for cutting steel plate (St37) not thicker than 4 mm.
Cutting tips can be ordered if desired.The cutting tips are placed on the spreading arms instead of the
spreading tips.
• Make sure that the spreading arms are slightly open.
• Press the lock pin (A) at the bottom and the top.
• Remove the spreading tip (B).
• Push the cutting tip (D) onto the spreading arm (C).
• Check that the cutting tip is properly locked by the lock pin.
• Repeat the action for the second cutting tip.
6 Use
6.1 General
The equipment of a rescue system must always be ready for use. That means the equipment must be
checked and inspected directly after use, before it is put away.
WARNING
Make sure you are up to date on all safety regulations and that you have mastered the use of
all equipment of the system you are going to work with.
6.2 Before use
• Before use, always check the State Of Charge of the battery pack. See section 3.5.
GSP 52* EVO 3 916.001.653_003
EN
43