EN
6.4
After use
6.4.1
Inspection
•
Check the battery level. Recharge the battery pack, if necessary. See section 3.5.
•
Check the unit for completeness, leaks and damage. Do not use the unit if it leaks or is damaged
and contact the Holmatro dealer.
•
Check the accessories used for completeness and damage. Replace them if the damage is
considerable.
•
Inspect the tips. Replace them if the damage is considerable.
•
Check the operation of the deadman's handle. It must return to the neutral position when you
release it.
•
Check that the carrying handle is firmly attached.
6.4.2
Storing the battery pack
NOTICE
When the battery pack is not in use, it is advised to keep the battery pack connected to the
battery charger (connected to a power source) at all times. When the battery pack is full, the
battery charger automatically switches on and off at regular intervals to keep the battery
level at 100%.
•
Store the battery pack in a dry and well-ventilated area. The maximum storage temperature (see
section 8.8) may not be exceeded.
•
Make sure the equipment can not fall over during transport.
6.4.3
Shut down
•
Close the spreading arms with the spreading tips slightly opened so that the tool can be stored
without pressure.
•
Switch the tool off.
•
Remove the battery pack and place it in the battery charger.
6.4.4
Cleaning and storage
•
Clean the tool and any accessories before storage.
•
Dry the tool if it was used in wet conditions. Apply a thin coat of preservative oil to the external steel
parts.
•
Store the tool in a dry and well-ventilated area.
7
Troubleshooting
7.1
General
Consult the Holmatro dealer if the listed solutions do not give the desired result, or in case of other
problems. For malfunctions or repair, always specify the model and serial number of the equipment.
NOTICE
If the battery pack has to be returned to the dealer for repairs, make sure that the battery
pack is packaged according to the specific instructions applicable for Li-Ion battery packs.
See section 8.7.
46
916.001.653_003
GSP 52* EVO 3