Beurer WL 50 Mode D'emploi page 37

Operation with USB mains adapter
1. Place the device near an easily accessible socket.
2. Connect the USB mains adapter to the USB-C cable.
3. Insert the USB-C cable into the USB-C port on the rear of the device.
4. Insert the USB mains adapter into a suitable socket. The AUX cable functions as an antenna.
On | Off
5. Slide the
6. The time is shown on the device display. The device is now ready for use.
Battery use / Charging the battery
1. Before using the device with the battery, you must charge the battery.
2. Connect the USB-C mains adapter to the USB-C cable.
3. Insert the USB-C cable into the USB-C port on the rear of the device.
4. Insert the USB-C mains adapter into a suitable socket. Whilst charging, the small red light next
to the USB-C port on the rear of the device will light up.
5. As soon as charging is complete, the small red light next to the USB-C port will go out. A
complete charging process lasts for approx. 4 hours.
6. Pull the USB mains adapter and the USB cable out of the socket and the device. The device
can now be operated with the battery.
On | Off
7. Slide the
8. The time is shown on the device display, along with the current battery state .
switch on the rear of the device to the "On" position.
switch on the rear of the device to the "On" position.
37