Publicité
◾
Check the parking brake pedal.
EN
Remove the battery from the
mower and set the parking pedal
at the braking position. Manually
push the mower forwards to
Annually
see whether the mower can be
moved or not. If it moves, have
it serviced by a qualified service
technician.
CLEANING THE MOWER (Fig. J1 – Fig. J10)
Preparation (Fig. J1 – Fig. J5)
Cleaning the mower housing (Fig. J6 - Fig. J7)
Using wash port to clean the mower deck
(Fig. J8 - Fig. J10)
J8-1 Wash Port
J8-2 Wash-Port Quick
Coupler
NOTICE: When finishing cleaning, push the PTO switch
downward to disengage the mower blades.
MAINTAINING THE MOWER DECK AND THE
CUTTING BLADES
Preparation (Fig. K1 – Fig. K6)
Removing the mower deck (Fig. K7 – Fig. K8)
K7-1 Motor Cable
K7-2 Cotter Pin
NOTICE: Disconnect all motor cables and cotter pins
when removing the mower deck.
Replacing the cutting blades (Fig. K9 - Fig. K11)
K9-1 Stabilizer
K10-1 Bolt
K10-2 Washer
Leveling the mower deck
a. When to level (Fig. K12 – Fig. K14)
b. Before leveling
◾
Checking the cold tire pressure (Fig. K15)
◾
Check the cutting blades. Remove and replace
worn, cracked, and/or bent blades as necessary.
28
ZERO TURN RIDE-ON MOWER — ZT5200E-L
J8-3 Garden Hose
K7-3 Suspension Linkage
K10-3 Blade
K10-4 Flange
K10-5 Motor Shaft
c. Preparation for leveling (Fig. K16 – Fig. K21)
d. How to leveling
◾
To make side-to-side adjustment (Fig. K22)
K22-1 Jam Nut
◾
To make front-to-rear adjustment (Fig. K23)
CALIBRATING THE MOWER TRACKING
SYSTEM (Fig. L1 – Fig. L4)
NOTICE: The beeping indicator will sound once both when
starting calibration and when the calibration is finished.
NOTICE: The calibration completed for one of the driving
modes ("CONTROL", "STANDARD", "SPORT") maybe not
available for the other two modes. Calibrate the steering
levers in each driving mode independently as needed.
RESETTING THE MOWER TO INITIAL FACTORY
SETTING (Fig. M)
NOTICE: The beeping indicator will sound once both when
starting resetting and when the resetting is finished.
NOTICE: When the resetting is successful, below settings
will return to the initial factory setting:
◾
driving mode
◾
driving speed
◾
calibration of the steering levers
STORAGE AND TRANSPORT
TRANSPORTING THE MOWER
(FIG. N1 – FIG. N11)
NOTICE:Secure the mower as needed, using straps or
cables to prevent movement during transport.
STORAGE (Fig. O1 – Fig. O6)
NOTICE: Remove the battery packs and store the
batteries refer to the corresponding manuals.
Clean and check the mower before storage refer
to the sections "CLEANING THE MOWER" and
"RECOMMENDED MAINTENANCE SCHEDULE(S)".
Publicité
