Publicité
c. To test the driving system (Fig. D6 – Fig. D8) then
EN
slowly stand up
If the deck-blade system and/or the driving system fails to
stop when the operator is off of the seat and if the cause
cannot be determined after confirming the plug and socket
connection of the seat is well connected, contact your EGO
customer service center immediately.
ADJUSTMENT (Fig. E1 – Fig. E13)
Preparation (Fig. E1 – Fig. E5)
Adjusting the cutting-deck height (Fig. E6)
Adjusting the anti-scalp wheels (Fig. E7 – Fig. E10)
E7-1 Anti-Scalp Wheel
E9-1 Nut
Adjusting the seat (Fig. E11)
Adjust the seat position to ensure you are able to
make firm contact with the parking-brake pedal before
operating the mower. Seat suspension adjustment could
make you achieve the most comfortable experience on
the seat.
Seat Position
E11-1
Adjustment Lever
Setting the parking brake (Fig. E12 – Fig. E13)
E13-1 Braking Position
CHARGING (Fig. F1 – Fig. F11)
In order to start this mower, EGO batteries totaling 15 Ah
(2 X BA4200/BA4200T) or more are required. For best
performance, we recommended use of EGO batteries
that total 30 Ah or more.
Use only with the recommended battery packs and
chargers. (Fig. F9 & F10)
Preparation for charging (Fig. F1 – Fig. F4)
Charging the battery pack(s) separately
(Fig. F5 – Fig. F9)
Cover Release
F5-1
Button
◾
To attach the battery pack(s) (Fig. F5 – Fig. F6)
◾
To detach the battery pack(s) (Fig. F7 – Fig. F8)
26
ZERO TURN RIDE-ON MOWER — ZT5200E-L
E9-2 Lag Bolt
E10-1 Deck Height Label
Seat Suspension
E11-2
Adjustment Knob
E13-2 Released Position
Battery Release
F7-1
Button
NOTICE:: Charge the battery pack(s) refer to the
corresponding battery and charger manuals.
Charging the battery packs via charging port
(Fig. F10)
F10-1 Dust Cap
STARTING THE MOWER (Fig. A4 – Fig. A5 &
Fig. G1 – Fig. G6)
WARNING: Avoid sudden starts, stops, and turns, as
well as excessive speed, especially when first learning to
operate the mower. The mower can spin rapidly, which
may cause you to lose control and result in serious injury
and/or damage.
WARNING: Before starting the mower, check and
make sure the blades are disengaged within 5s when
pushing the PTO switch downward. If the blades fail
to stop, do not use the mower and contact your EGO
customer service immediately.
NOTICE: Follow Fig. A4 & Fig. G2 to get the lowest
driving speed and STANDARD driving mode until you are
fully capable of operating the mower in all situations.
The driving speed and driving mode will activate only
when the mower wheels are stopped and the steering
levers are open.
The mower will save and present the previous driving
mode, driving speed and calibration of the steering
levers when restarting it.
Driving-Mode
◾
CONTROL: Lower acceleration, less sensitive
handling, and mild turning speed to protect the
grass and for new users.
◾
STANDARD: Perfect for everyday use.
◾
SPORT: Higher acceleration, accurate handling, and
sharp turning to maximize mowing efficiency and
for mowing enthusiasts.
Driving Speed Adjustment (Fig. A4)
Blade Speed Adjustment (Fig. A5)
USB port
NOTICE: The USB port provides charging power of 5
Voltage DC at up a combined draw of 1.5 Amperes and
is powered only when the mower is startup.
F10-2 Charging Port
Publicité
