Mitsubishi Electric MSZ-HA25VA Notice D'utilisation page 4

NAME OF EACH PART
Remote controller
Signal transmitting section
Operation display section
ON/OFF (operate/stop) button
Fan speed control button
Operation select button
Timer mode select button
NOTE
Use the remote controller provided with the unit only.
Do not use other remote controller.
Optional parts Optional parts are available from your local dealer.
Name of parts Type name
REMOTE CONTROLLER HOLDER MAC-1200RC
Refer to page 5 (Handing of the remote controller)
4
PREPARATION BEFORE OPERATION
Auto restart function
I
These models are equipped with an auto restart function. If you do not want to use this function,
please consult the service representative because the setting of the unit needs to be changed.
Auto restart function is ...
When the indoor unit is controlled with the remote controller, the operation mode, the set temperature and the fan speed are
stored in the memory. If a power failure occurs or the main power is turned off during operation, "Auto restart function" sets
automatically to start operating in the same mode as the one set with the remote controller just before the shutoff of the main
power. (Refer to page 5 for details.)
Power supply
I
Insert the power supply plug into the power outlet and/or turn the breaker on.
WARNING:
Remove dirt from the power supply plug and insert the plug securely.
If dirt adheres to the plug or insertion is incomplete, it may cause a fire or an electric shock.
Remote controller (How to set the batteries)
Temperature buttons
1
Remove the back lid and insert batteries.
ECONO COOL button
Then reattach the back lid.
Vane control button Insert the minus pole of the batteries first.
Check if the polarity of the batteries is correct.
Time set buttons
RESET button
2
Press the RESET button.
Press using
a thin stick.
Insert the minus pole of
the batteries first.
• If the RESET button is not pressed, the remote con-
troller may not operate correctly.
• Be sure to press the RESET button not too strongly.