Publicité
Les langues disponibles
Les langues disponibles
5"
(127 mm)
5" (127 mm)
1. Install the Supply Piping – Single Supply
Route the water supply lines.
Use the provided soldering template to construct a pressure
balancing loop.
Position tees in the loop over each of the four raised locations on
the template.
Solder the assembly while it is attached to the template.
Remove the pressure balancing loop from the template.
Connect the pressure balancing loop to the water supply.
Do not strap the pipes.
Temporarily install a nipple to each tee. Do not use any sealant.
Kohler Co.
Pressure
Balancing Loop
Soldering Template
1/2" NPT Nipple
3
Tee
1207715-2-C
Publicité
