Publicité
Les langues disponibles
Les langues disponibles
Sprayface
8. Install the Sprayface
NOTE: For product with brushed finishes, align the brush pattern
of the sprayfaces with the direction of the brushed pattern of the
escutcheon.
Tilt the sprayhead to expose the ribs.
Position the grooves of the sprayface over the ribs, then rotate the
loose end of the sprayface up as illustrated.
Press the sprayface into place to cover the sprayhead.
Tilt the sprayhead assembly to expose the setscrew holes.
IMPORTANT! To avoid product damage, the setscrews must not
protrude beyond the sprayface.
Using a 5/64" hex wrench, turn the setscrews counterclockwise
until they are flush with the sprayface.
Repeat for the remaining sprayfaces.
Care and Cleaning
For best results, keep the following in mind when caring for your
KOHLER product:
• Use a mild detergent such as liquid dishwashing soap and warm
water for cleaning. Do not use abrasive cleaners that may scratch
or dull the surface.
• Carefully read the cleaner product label to ensure the cleaner is
safe for use on the material.
Kohler Co.
Sprayface
Ribs
Setscrews
11
1207715-2-C
Publicité
