Eurosystems FT 92 Manuel D'utilisation Et D'entretien page 38

guards is negative, interrupt all the op-
erations.
5.8. USE
DANGER!
Always pay particular attention when
the PTO is engaged.
DANGER!
Always use the personal protection de-
vices required in the paragraph "Cloth-
ing".
DANGER!
Never leave the work operating position
behind the handlebars when the ma-
chine is working
[ fig. 02 ]
the machine unguarded with the engine
running.
DANGER!
Do not adjust the handlebar when the
machine is moving.
DANGER!
Be careful of the hot parts of the ma-
chine like for example the muffler and
the muffler protection.
DANGER!
If the machine and/or the accessories
should get clogged up, turn off the en-
EN-12
gine and remove the ignition key and/or
the spark plug hood before intervening.
If the tool, the accessory or the ma-
chine gets damaged, immediately turn
off the engine.
For specific descriptions of the respecti-
ve commands refer to chapter "Use" and
"Operating commands" in the machine's
operation and maintenance manual.
5.9. CLEANING DURING THE WORKING
DAY
If it becomes necessary to clean the ma-
. Never leave
chine during the day (weeds, dirt, mud
etc.) turn off the engine and remove the
ignition key and/or the hood of the spark
plug to prevent inadvertent starting.
Before entering the danger zone, wait
for all the machine's moving parts to
come to a standstill (at least ten sec-
onds from the stopping of the engine).
Wait for the hot parts of the machine to
cool down (at least 15-20 minutes).
DANGER!
DANGER!
DANGER!