Publicité
Les langues disponibles
Les langues disponibles
Connect my Board Buddy
Transmitter connection
9. Connect the source signal (computer, tablet, Chrome Book, MacBook, etc.) from which
the presentation originates to the HDMI IN socket.
10. If a monitor (the presentation screen or smartboard) is already connected to the source
signal, you can now connect the my Board Buddy to the HDMI OUT socket.
11. Plug in the 12V power adapter.
12. Turn on the switch.
The my Board Buddy transmitter starts up. If a monitor is connected to the HDMI OUT socket,
the Sensotec logo appears, then the source signal is visible. As soon as both LEDs light up, the
transmitter is fully powered up and ready to use.
Receiver connection
Optional: if you wish to install the Board Buddy on the rear of the screen, use the VESA adapter
and screws supplied.
7. Connect the display (the student's monitor) via an HDMI > HDMI or HDMI > DVI cable.
8. Connect the controller to one of the 4 USB ports on the side of the emitter
9. Connect the power adapter to the micro USB port and plug it into the wall socket.
If all goes well, you'll see the Sensotec start-up screen followed by a screen with the my Board
Buddy logo. If there's a transmitter nearby with an available image signal, it will connect
automatically.
Working with my Board Buddy
Using my Board Buddy is all about convenience, so users quickly get used to the device and
how it works. As soon as a transmitter is available in the vicinity of the receiver, it connects
automatically without the intervention of any third party. Users can enlarge the image and
manipulate colors.
3
1
16
4
3
2
1
2
Publicité
