Sensotec my Board Buddy AIR Manuel page 16

Working with transmitter connections
Electrical adapter
The my Boardy Buddy transmitter features a DC connection for the 12V power adapter.
HDMI input
The my Board Buddy transmitter has an HDMI input with Full HD support (1080p, 1920x1080),
or you can connect a DVI source using a DVI-to-HDMI cable. VGA format is not supported! The
image connected to the input will be available wirelessly to the receiver.
HDMI output
The my Board Buddy transmitter features an HDMI output with Full HD support (1080p,
1920x1080). The signal you connect to the input is available again on the output. So there's no
need for an HDMI splitter. It's also possible to connect a DVI display, using an HDMI-to-DVI
cable.
Working with receiver connections
Electrical adapter
The my Boardy Buddy receiver has a micro USB connector for the power adapter, so don't plug
it in until you've made all the following connections.
HDMI output
The my Board Buddy receiver has an HDMI output with Full HD support (1080p, 1920x1080).
It's also possible to connect a DVI display, just use an HDMI-to-DVI cable. VGA is not
supported!
USB connection
The my Board Buddy receiver has 4 USB connections, only one of which is permanently used
by the controller.
15