FARFISA INTERCOMS Profilo ZH1262PLB Mode D'emploi page 33

System settings. This menu allows the user to set user
addresses, room addresses, additional parameters and
Forwarding A1 (see "System menu" section).
Default settings. It enables resetting the factory settings of
the device; if there are any intercommunicating devices,
entrances and actuations programmed, such entries will not
be deleted.
Advanced Settings. Procedures and information protected
by password that can only be accesses by Aci Farfisa technical
service.
Technical characteristics
Power supply directly from the line
Stand-by current:
Operating current:
Screen:
Television standard:
Horizontal frequency:
Vertical frequency:
Band width:
Operating temperature:
8mA
280mA
3.5" LCD
PAL
15625Hz
50Hz
>5MHz
0° ÷ +40°C
System Menu
Address
Room
Supplementary Supplementary
addresses addresses
Address. Enter the user address corresponding to that
memorized in the external stations and the door station.
Numbers from 001 to 200.
Room. Address that uniquely identifies all the devices installed
in the same apartment (with the same user address).
Numbers from 000 (main device) to 009 (secondary devices).
Supplementary addresses. Addresses of other users to
which the device must answer. Beside the additional user
address, it is required to set the correctly room number.
Forwarding A1. Enables or disables redialing floor call
(doorbell) to other devices installed in the same apartment. It
is also possible to enable advanced functions (contact the
technical support service of Aci Farfisa).
The Zhero videointercom uses a freeRTOS operating
system (http://www.freertos.org).
Sounds and ringtones by: http://www.freesfx.co.uk
For further information visit:
- 33 -
Forwarding Forwarding
A1 A1
Back
http://www.audionatix.com
www.acifarfisa.it
mail: info@acifarfisa.it
Mi 2479