Télécharger Imprimer la page

Dolmar BBX7600CA Instructions D'emploi page 10

Publicité

Les langues disponibles

Les langues disponibles

BEFORE STARTING THE ENGINE
1. Checking and Refilling Engine Oil
1) Follow the procedure below when the engine oil is cold i.e. the blower has not
been running.
Inspection: Set the blower down on a level surface and remove the oil cap. Verify
that the oil level is within the upper and lower limit marks on the oil
level gauge. If the oil is not up to the 100mL level, fill up with new oil.
Adding Oil: Set the blower down on a level surface and remove the oil cap. Fill the
oil up to the upper limit of the oil level gauge.
2) On average, engine oil normally needs to be added after every 20 hours of
operation. This interval for every change in oil corresponds to refueling the
blower approximately 10-15 times.
3) Please change the oil whenever it becomes dirty or significantly changes color.
(Refer to p. 15 for the oil change procedure and frequency.)
Recommended oil: MAKITA genuine oil or SAE10W-30 oil of API type SF grade or better (4 stroke motor oil for automobiles)
Oil capacity: Approximately 0.22 L (220 ml)
• If the blower is not stored in an upright position, the oil may flow from the level gauge into the engine and give a false reading when
checking the oil level. This may result in inadvertently overfilling whenever adding engine oil. Always store in an upright position.
• If the upper oil level limit is exceeded, this can result in the oil becoming dirty and white smoke from burning excess oil.
Check Point #1: Concerning the oil cap when adding oil
• Wipe off dirt and grime around the opening before removing the oil cap.
• Remove the oil cap and place it on a clean surface so that it does not accumulate any sand, dirt, or other foreign bodies. These may
stick to the cap and adulterate the engine oil if proper care is not taken. Dirty oil containing sand, dirt, or foreign bodies may cause
excessive wear on the engine due to improper lubrication and result in a breakdown.
Check Point #2: If oil is spilled when adding oil
• Oil spillage on the outside on the blower may result in the engine oil becoming dirty or adulterated. Therefore, please wipe off any oil
spillage before starting the engine.
CAUTION
10
Get other manuals https://www.bkmanuals.com
Oil level gauge
Upper limit
Remain 100 mL
Lower limit

Publicité

loading

Ce manuel est également adapté pour:

Bbx7600