Technical Specifications - Velleman VTSS4NU Mode D'emploi

After removing the tip, blow out any oxide dust that may have formed in the tip receptacle. Be
careful not to get dust in your eyes. Replace the tip and tighten the screw. You can use pliers to
avoid contact with hot surfaces but use with caution because over-tightening may cause damage
to the element or fuse the tip to the element.
Clean the outer cover of the iron and station with a damp cloth and a small amount of liquid
detergent. Never submerge the unit in liquid or allow any liquid to enter the case of the station.
Never use any solvent to clean the case.
If the iron or station become faulty or, for some reason do not operate normally, return them to the
service department of your authorized dealer or service agent.
9.

Technical Specifications

max. heater power for soldering iron
temperature range
voltage supply
weight
replacement bits
Use this device with original accessories only. Velleman Inc. cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device.
For more info concerning this product and the latest version of this manual, please visit our
website www.vellemanusa.com.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman Inc. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 01 – 30/05/2013
VTSS4NU
48 W
302 - 842 °F
110 Vac
20.8 oz
order code BITS5
6 ©Velleman Inc.