AEG AGN1811 Notice D'utilisation page 12

12 www.aeg.com
WHAT TO DO IF...
WARNING!
Before troubleshooting, discon-
nect the mains plug from the
mains socket.
Only a qualified electrician or
competent person must do the
troubleshooting that is not in this
manual.
Problem
The appliance does
not operate. The Pi-
lot light does not
flash.
The Pilot light flash-
es.
The Alarm light flash-
es.
The compressor op-
erates continually.
The temperature in
the freezer is too
low.
The temperature in
the freezer is too
high.
Possible cause
The appliance is switched
off.
The mains plug is not con-
nected to the mains sock-
et correctly.
The appliance has no
power. There is no voltage
in the mains socket.
The appliance is not work-
ing properly.
The temperature in the
freezer is too high.
The temperature is not set
correctly.
The door is not closed cor-
rectly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
The temperature regulator
is not set correctly.
The Fast Freeze function is
switched on.
The temperature regulator
is not set correctly.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Contact a qualified electri-
cian.
Refer to "Excessive Tem-
perature Alarm"
Set a higher temperature.
Refer to "Closing the
door".
Do not keep the door open
longer than necessary.
Let the product tempera-
ture decrease to room tem-
perature before storage.
Decrease the room temper-
ature.
Set a higher temperature.
Refer to" Fast Freeze func-
tion".
Set a lower temperature.