fadini DARDO 424 Notice D'instructions page 21

DARDO 424 DARDO 424
FIXING TO GATE POST
Remove the rear cap protecting the electrical connections, located at the back of the operator.
Make the opertor rear fork-like bracket to fit the gate post fixing plate on to the central hole (lateral holes are provided to adjust
the rear fixing in case A and B distances might be wrong).
FIXING TO GATE
Open the gate by hand and bring it close to the operator. Swing this one on to the front bracket so that the fastening pin fits into
the bush of the front fixing plate, then tighten the locking screw, avoid overtightening.
electromechanical operator for swinging gates
Locking screw
IMPORTANT: IT IS RECOMMENDED THAT
SOME GREASE BE PUT ON THE BOLT AND
GREASE
THE SURFACE OF THE FIXING PLATE
Screw the locknut: avoid overtightening and
!
undo half a turn approx. in order to allow for
a smooth rotation without friction
!
IMPORTANT: RECOMMENDED.
PUT SOME GREASE ON THE
GREASE FASTENING PIN
21
!
Pic. 9
Pic. 10