Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS ( CONTINUED )
Outlet
Adapter
#222
O-ring
Figure 5
Install Hose and Nozzle
1.
Wrap one end of the dispensing hose with three to four turns of thread tape
and thread into outlet port. Tighten securely using an adjustable wrench.
2.
Wrap opposite end of hose with three or four turns of thread tape
and thread into nozzle. Tighten securely using an adjustable wrench.
3.
Place the nozzle into the nozzle holder on the end of the pump motor
housing. Note that the nozzle cannot be placed in the holder unless
the pump switch is OFF (see Figure 9).
12
EN
M6-1.0 x 20mm
SHCS
Nozzle Cover
M6-1.0 x
14mm BHCS
Publicité
