Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS ( CONTINUED )
Figure 2
24" - 40" Extension Pipe
Figure 4
Install Pump on Tank
Using pliers, remove the plastic plug from inlet port on bottom of pump, then using a
wrench, tighten the pump onto the adapter.
Install Nozzle Cover
Using a 4mm Hex wrench, install nozzle cover using (2) M6-1.0 x 14mm BHCS in
lower hole (see Figure 5).
NOTE: For models V25-012PO/PX and V25-024PO/PX only, DO NOT install
nozzle cover until after wiring is completed.
Install NPT Outlet Adapter
1.
Remove plastic plug from outlet port of pump.
2.
Install #222 O-ring into outlet port. Make sure O-ring is seated properly.
3.
Using a 5mm Hex wrench, install the (4) M6-1.0 x 20mm SHCS into the
1 in. NPT outlet adapter in desired direction on outlet port (see Figure 5).
EN
Figure 3
15" - 24" Telescoping Suction Pipe
11
Publicité
