ZANKER KBB25011SK Notice D'utilisation page 23

Installation
Warning! Refer to Safety chapters.
Positioning
Install the appliance in a dry, well ventilated indoors
where the ambient temperature corresponds to the
climate class indicated on the rating plate of the
appliance.
Climate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be guaranteed
within the specified temperature range. If
you have any doubts regarding where to
install the appliance, please turn to the
vendor, to our customer service or to the
nearest Authorised Service Centre.
Electrical connection
• Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to
your domestic power supply.
• The appliance must be earthed. The power supply
cable plug is provided with a contact for this
purpose. If the domestic power supply socket is not
earthed, connect the appliance to a separate earth
in compliance with current regulations, consulting a
qualified electrician.
• The manufacturer declines all responsibility if the
above safety precautions are not observed.
• This appliance complies with the E.E.C. Directives.
Ventilation requirements
The airflow behind the appliance must be sufficient.
Ambient temperature
5 cm
min. 200cm
min.
200cm
Door reversibility
1. Loosen and remove the upper pin and spacer.
2. Remove the upper door.
3. Loosen the middle hinge.
4. Remove the door.
5. Remove the lower spacer.
6. Loosen the lower pin with a key.
7. Tighten the lower pin on the opposite side.
8. Install the lower spacer.
9. Install the door.
10. Tighten the spacer and the upper pin.
2
2
23