ZANKER KBB25011SK Notice D'utilisation page 22

Problem
Water flows on the rear plate of the
refrigerator.
Water flows into the refrigerator.
Water flows on the floor.
The temperature in the appliance is
too low/too high.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
1. Pull the left side of the lamp cover with your fingers
to unlock it. Remove the cover by pulling it towards
yourself.
22
Possible cause
During the automatic defrosting
process, frost melts on the rear
plate.
The water outlet is clogged.
Food products prevent that water
flows into the water collector.
The melting water outlet is not con-
nected to the evaporative tray
above the compressor.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is greater
than 4-5 mm.
The door has been opened often.
There is no cold air circulation in the
appliance.
1
2
1
This is correct.
Clean the water outlet.
Make sure that food products do not
touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature
decrease to room temperature be-
fore storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air cir-
culation in the appliance.
2. Replace the lamp with one of the same power and
shape, specifically designed for household
appliances. The maximum power is shown on the
light bulb cover.
3. Install the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light switches on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to assembly
instructions.
3. If necessary, replace the defective door gaskets.
Contact the Authorised Service Centre.
Solution