Volpi KV300 Mode D'emploi page 37

5) Release the trigger when you hear the motor turning.
6) The electric motor rotates during calibration. When the motor stops turning the calibration is
complete.
16. Pruner Storage
The most important thing to keep in mind before storing your pruner's lithium ion batteries is to make
sure that the batteries are fully charged up. Storing your battery pack for long extended periods with
little or no charge will damage your battery and void your warranty.
1) Ensure that the battery is fully charge.
2) Avoid storing the device in extremely hot or cold environments.
3) If the device will not be used for a long time, remove the battery before storing it.
4) Batteries and chargers must be placed in a secure location prevent heat, dust and moisture from
entering.
5) Batteries should be stored in a dry environment.
Recommended storage temperatures:
• The battery and flammable matter must be kept at least 5-feet apart.
• In order to ensure the service life of the equipment and to prevent its degradation, it must be stored
with enough battery power.
• When not in use, charge the battery at least once every 3 months.
17. Tool indications and warning signals
17.1. Charge level indication
To determine your pruner battery charge level your pruner is supplied with a simple to read LED readout
which features 3 green and 1 red light. To illuminate the readout, hold the button down on the handle
of the tool. The readout is located on the back of the handle.
When all 3 green lights are illuminated then your battery is near to full capacity. Depending on
operating variables such as diameter of cut, density of wood and frequency of the cuts a typical battery
charge will last 3-4 hours.
Storage less than 1 month
Storage less than 6 month
Storage over 6 month
-20°C ~ +60°C
-10°C ~ +35°C
0°C ~ +30°C
37