Volpi KV300 Mode D'emploi page 35

With the removal of the cover, adjustment clip, gear nut, and center bolt you can access, maintain,
clean, lubricate and replacement of blades when necessary.
1. Loosen adjustment clip bolt with allen
wrench
3. Loosen gear nut with wrench.
5. Unscrew 4 cover screws with allen wrench.
7. Apply grease to recess in blade.
2. Remove adjustment clip bolt and adjustment
clip.
4. Remove adjustment gear nut.
6. Remove cover and disassemble blade set.
8. Apply grease to gear teeth and center bolt
hole.
35