Volpi KV300 Mode D'emploi page 36

9. Assemble blade set, place cover and insert
center bolt.
11. Place gear nut on center bolt.
13. Secure gear nut with clip and insert bolt.
15.4. Tool Calibration
If a replacement motor or drive plate is required, the pruners need to be recalibrated.
Follow next steps to perform the calibration:
1) Remove the upper and lower blades.
2) Insert the battery.
3) Hold down the trigger and keep it pressed. Press the POWER switch again.
4) Maintain the trigger pressed for more than 10 s.
36
10. Tighten 4 cover screws with allen wrench.
12. Tighten gear nut with cresent wrench.
14. Tighten gear nut clip bolt securing the
centerbolt gear nut.