Holmatro AHS 1400 FDU Mode D'emploi page 34

EN
Possible cause
There is air in the system.
8 Maintenance
8.1 General
For standard installation instructions, refer to the Service & Support section of the Holmatro website.
Proper preventive maintenance of the equipment preserves the operational safety and extends the life
of the equipment.
WARNING
When performing maintenance activities, always comply with the relevant safety regulations.
Wear the prescribed personal protection equipment.
8.1.1 Dangerous substances
WARNING
Used or leaked fluids, and any other products consumed during the activities, must be
collected and disposed of in an environmentally responsible way.
8.2 Maintenance materials
/i
Application
Steel parts
Hydraulic couplers
Hydraulic system
Contact the Holmatro dealer for information on spare parts.
8.3 Maintenance schedule
This schedule is an average. Depending on the intensity of use of your equipment, Holmatro can
provide a specific maintenance schedule for you.
34
Type of maintenance material
WD-40 preservative oil
Tectyl ML from Valvoline (long term preservation)
WD-40 preservative oil
Hydraulic oil: ISO-L HV VG 15
916.219.125_005
Solution
CORE™ system:
• Disconnect the hose from the tool.
• Let the pump run idle for one minute.
• Connect the tool.
• Open and close (entirely) the tool once.
Dual-hose system:
• Disconnect the hoses from the tool and
connect them to each other
• Let the pump run idle for one minute.
• Disconnect the hoses and connect the tool.
• Open and close (entirely) the tool once.
Amount
As required
As required
As required
As required
AHS