Philips Satinelle Ice HP6492 Mode D'emploi page 14

ENGLISH
14 14
Problem
The pivoting
cooling head
of the skin
cooler doesn't
move.
The epilating
head cannot
be removed.
The shaving
head cannot
be removed.
Reduced
shaving
performance.
Stronger skin
irritation than
usual after
shaving.
Cause
The skin cooler was not put in
the freezer or freezing
compartment.
The skin cooler does not
touch the skin.
The pivoting cooling head is
frozen.
You are not moving the
epilating head in the right
direction.
You are not moving the
shaving head in the right
direction.
The shaving head is dirty.
The shaving foil is damaged or
worn.
Solution
Put the skin cooler without
the insulating sleeve in the
freezer or freezing
compartment (***) for at
least 4 hours. Do not store
the skin cooler in the
refrigerator.
Make sure the skin cooler is
always in proper contact with
your skin during epilation.
Pass the skin cooler over your
leg a few times to make it
start pivoting again. Always
make sure the outside of the
skin cooler is completely dry
before you freeze it.
Press the release button and
move the epilating head in the
direction of the arrow (fig. 6)
to remove it.
Press the release button and
move the shaving head in the
direction of the arrow (fig. 6)
to remove it.
Switch the appliance off,
unplug it and remove the
shaving foil.Then clean the hair
chamber and the cutter unit
with the cleaning brush
supplied. Remove any hairs
that may have got stuck under
the trimmers.
Replace the shaving foil if it is
damaged or worn.