Philips Satinelle Ice HP6492 Mode D'emploi page 13

Problem Cause
The skin was moistened with
water, or a cream or other
skincare product was applied
prior to epilation.
The appliance The socket to which the
does not appliance is connected is not
work. live.
The appliance is not switched
on.
The epilating head has not
been attached correctly.
Skin irritation You used the epilator for the
occurs. first time or after a long
period of disuse.
The skin The skin cooler was not
cooler is not frozen long enough.
cold enough.
ENGLISH
Solution
Make sure your skin is entirely
dry and free from grease. Do
not put any cream, body milk
or other skincare product on
your skin before you start
epilating.
Make sure the socket you use
is live. If you are using a socket
in a bathroom cabinet, you
may need to switch on the
light to activate the socket.
Make sure that the appliance
is plugged in and switched on.
Place the epilating head on the
appliance and press it onto
the appliance until it snaps
home ('click').
Some skin irritation may occur
the first few times you use the
appliance.This is absolutely
normal and should quickly
disappear. For tips to reduce
skin irritation, see the first
section of chapter 'Using the
appliance'. Also make sure you
keep the epilating head clean.
Put the skin cooler without
the insulating sleeve in the
freezer or freezing
compartment (***) for at
least 4 hours.When the
colour of the fluid has changed
from white to completely
blue, the skin cooler is ready
for use.
13 13