Publicité
2-6. Plug Connections
2-7. Threading And Feeding Welding Wire
Tools Needed:
WIRE ADVANCE
Push wire thru guide up to drive rolls; continue to
hold welding wire. Press Wire Advance push but-
ton until drive rolls grab wire. Adjust tension until
wire does not slip. Indicator is for reference only.
OM-1597 Page 12
2
POWER
ON
V
OFF
Weld Control
Welding Power Source
Set switches.
Press Wire Advance push button until
wire comes out of gun. Feed wire to
check drive roll pressure. Adjust knob
enough to prevent slipping. Do not over-
tighten.
1
2
1
3
To make connections, align key-
way, insert plug, and tighten
threaded collar.
3
Hold wire tightly to keep it
from unraveling.
Pull and hold wire; cut off end.
WOOD
Weld Control
Motor Control Cord (Not
Supplied)
Motor/Drive Assembly
DP-0001 / 802 269
6 in
(150 mm)
Cut off wire at a diagonal.
Close cover.
Ref. ST-153 072 / Ref. ST-156 798
Publicité
