Troubleshooting; Fault Causes And Remedies - BDS Maschinen MAB 855 Mode D'emploi

Troubleshooting

Troubleshooting

Fault causes and remedies

Fault
The motor does not start
after pressing the ON/
OFF switch or stops during
operation.
The automatic circuit
breaker in the electrical
distribution board trips.
The magnetic clamp does
not function.
The lubrication system
does not function.
NOTE
►
If you cannot resolve the problem with the steps described above, please contact
the customer service.
54
Possible cause
Plug not inserted into socket.
Automatic circuit breaker
tripped.
The magnetic clamp is not
switched on.
Too many appliances con-
nected to the same power
circuit.
The machine is defective.
Magnet not switched on.
The surface is not magnetic.
No lubricant available.
Lubricant tap closed.
Connecting nipple clogged.
Remedy
Insert plug.
Switch on the automatic circuit
breaker again.
Switch on the magnetic clamp.
Reduce the number of appli-
ances on the power circuit.
Contact customer service.
Switch on magnet.
Use a suitable base.
Top up the lubricant.
Open the lubricant tap.
Clean the tank and nipple.
MAB 855