Inserting The Tool - BDS Maschinen MAB 855 Mode D'emploi

Steel with low thickness
NF metals or workpieces with an uneven surface

Inserting the tool

MAB 855
When drilling into low thickness steel, an additional steel plate
(minimum dimensions 100 x 200 x 20 mm) must be placed under
the workpiece. Secure the steel plate to prevent it from falling.
A special holding device must be used when drilling into NF met-
als or into workpieces with an uneven surface.
NOTE
►
BDS offers a range of accessories with special clamping
devices for tubes and non-magnetic materials.
The machine is equipped with an MK tool holder. Depending on
the type of tool to be used, corresponding drill chucks, quick-
clamping systems or adapters must be used.
Tool
Tools with
MK3 taper
Tools with
MK2 taper
Tools with
19 mm Weldon
shank
Tools with
32 mm Weldon
shank
Tools with
straight shank
Tool holder to be used
Insert the tool directly into the spindle taper
(3).
Use MK3:2 adapter sleeve
(available as an accessory).
Use 19 mm MK3 industrial holder/Weldon
(A).
Use 32 mm MK3 industrial holder/Weldon
(B).
Use drill chuck with MK3/B16 tapered man-
drel (available as an accessory).
Preparation
45