ARDES AR7440 Mode D'emploi page 11

Only these parts are intended to come in contact with food: 2, 3, 3A, 4, 5, 6, 7, 8, 9, 10, 11,
12, 13, 14, 15, 16 (see Technical information section).
- Type of foods: meat, tomatoes, vegetables and fruit for conserves and jam.
- Maximum temperature: 40°C.
- Maximum time: 10 minutes.
These accessories can be used only with this appliance.
"TOMATO PROCESSOR" use (AR7450 – AR7460)
FIRST USE
Before using the appliance for the first time, wash the parts in contact with food as specified in
section MAINTENANCE.
Position the motor base unit (1) on a flat stable surface.
Make certain that the plug of the power cord is not inserted into the power outlet and that the
power switch (19) is positioned on "0".
Position the feed channel (2) in the appropriate coupling (1A) on the motor base unit (fig. 1).
While pressing the lock/release button (17), rotate the feed channel anticlockwise in order to lock
it in position.
Make certain that the Teflon gasket and metal washer are assembled on the worm (7) and that
they are both intact. If not, they must be replaced.
Insert the worm (7) into the feed channel, fixing it on the motor pin (fig. 2).
Position the pulp collection tray on the feed channel.
Position the conic extension worm (8) on the worm (7), as illustrated in fig. 3, and insert the conic
sieve (3) into the feed channel.
Insert the ring nut on the conic sieve and position the pulp collection tray on the end of the same.
Screw on the ring nut, tightening it by hand.
While tightening the ring nut with one hand, hold the feed channel steady with the other (fig. 4).
1A
FIG.1
2
13
FIG.4
2
At this point, screw the plastic adjusting screw (3A) into the appropriate seat on the sieve (fig. 5)
and position the tray (4) on the feed channel.
Attach the plastic splash guard (5) onto the sieve, position a container at the end of the pulp
collection chute to collect the pulped tomatoes and another under the end of the sieve to collect
the scraps (fig. 6).
Food contact
7
1
2
FIG.2
7
FIG.3
8
GB
GB
11