Drive DeVilbiss Healthcare AirForce Mini Mode D'emploi page 35

Guidance and manufacturer's declaration - electromagnetic emissions
The device is intended for use in the electromagnetic environment specified
below. The customer or the user of
Emission test
Emissions RF
CISPR 11
RF Emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Guidance and manufacturer's declaration - electromagnetic emissions
The AirForce Mini is intended for use in the electromagnetic environment specified below. The
custo- mer or the user
Immunity test
IEC 60601 Test level
Electrostatic
±8 kV contact
discharges
±15 kV air
IEC 61000-4-2
NOTE: UT is the a.c. mians voltage prior to application of the test level.
this device
an environment
Compliance
Group 1
Class B
Class A
Complies
f
o this device should assure that it is used in such an environment
should assure that it is used in such
Electromagnetic environment – guidance
The A irForce Mini uses RF energy only for its inter-
nal function. Therefore, its RF emissions are very
low and are not likely to cause any interference in
nearby electronic equipment.
The device is suitable for use in all
establishments other than domestic and those
directly
connected to the public low-voltage power supply
network that supplies buildings used for domestic
purposes.
Compliance level
±8 kV contact
±15 kV air
Electromagnetic
environment - gui-
dance
Floors should be wood,
concrete or ceramic tile.
If floors are covered with
synthetic material, the
relative humidity should
be at least 30 %.
EN
33