Publicité
Les langues disponibles
Les langues disponibles
SPECIFICATIONS
Cat. No. ..................................................... 2356-20
Battery Type .................................................M12™
DC Input Volts....................................................12 V
Output Volts USB-A .............................................5 V
Output Amps USB-A ......................................... 2.1 A
Output Volts USB-C ............................................ 5 V
Output Amps USB-C............................................ 3 A
Operating Temperature
Battery and Tool ................................-4°F to 104°F
FUNCTIONAL DESCRIPTION
4
3
2
1
10
1. Light
2. Storage compartment
3. Battery cover
4. USB-C port
5. USB-A port
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To insert the battery, tilt the battery bay into the
"insert/remove" position. Insert the battery, ensuring
it latches securely into place. Tilt the bay back down
into the "use" position.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
7
6
8
5
6. Fuel gauge
7. Power button
8. MODE button
9. USB power button
10. Handle
To reduce the risk of injury, do not
CAUTION
stare at the operating light source.
To determine the amount of charge left in the bat-
tery, turn the tool ON. The fuel gauge will remain lit
when the tool is ON. If the light is off but a USB port
is being used, the fuel gauge will light for 3 seconds.
When less than 10% of charge is left, 1 light on the
fuel gauge will flash 4 times.
To signal the end of charge when the light is ON,
1 light on the fuel gauge will flash until battery is at
0% and the tool turns off automatically. Charge the
battery pack.
9
If the battery becomes too hot, the fuel gauge lights
will flash and the tool will not run. Allow the battery
to cool down.
1. Insert the battery.
2. Press the power
3. Press the MODE button to cycle through High,
Medium, and Low.
4. Press the power
NOTE: The light will default to the selected brightness
the next time it is turned on.
Rotating the Light
To reduce risk of overheating, en-
CAUTION
sure the light is turned off before
storing or placing in the resting position.
To rotate the light, pull the light upward and rotate
up to 20° counter clockwise or 280° clockwise. The
resting position is LED light facing down into housing.
USB Power Outlets
This outlet can be used to charge a cell phone, power
an MP3 player or any other device that uses less than
2.1A of DC electrical current (USB-A) and less than
3A of DC electrical current (USB-C). To turn on the
USB outlets, press the USB power
USB power button will remain illuminated when de-
vices are charging. If connected USB load is <50mA,
the ports will remain active for 2 hours. If connected
USB load is <25mA, the ports will automatically turn
off after 90 seconds.
NOTE: Any device that uses more than the above
DC electrical current values will trip a self-resetting
overload and disable the output.
3
OPERATION
Fuel Gauge
Using the Light
button to turn ON the light.
button to turn OFF the light.
button. The
Publicité
