Beper 50.933H Manuel D'instructions page 17

Steam iron Use instructions
TEMPERATURE SETTING
Always check the washing and ironing labels of clothes. If necessary, see instructions
below:
SYMBOL
The number of points on the thermostat (8) indicate the temperature from the lower one (•)
to the higher one (•••).The table is valid for fabrics and not for brilliant surfaces, with relief
printings or folds which must be ironed with low temperature.
Before using the iron, always make sure that the temperature of iron is adapted to the type
of fabric: wool with wool, cotton with cotton, etc.
The iron heats quickly and cools slowly; thus always start with clothing which requires a
low temperature (like synthetic fabrics) and always progress with the highest temperatu-
res..
When the cloth is made of several fabrics, set the temperature for the most delicate fabric.
If you do not know the type of fabric we recommend to iron the internal parts of clothing,
from lowest temperature, and then finding the temperature more adapted. If clothing beco-
mes "brilliant", stop immediately in order to not damage it. Then start to iron it on the back.
N.B. Pay attention to the symbol
STEAM IRONING
Before plugging the appliance, make sure the tank (2) is full of water.
Check the steam indicator (3) is on position « steam »
When used for the first time, press several times steam switch (4), in order to eliminate
dirt, residue from the manufacture.
Steam ironing is possible when setting the thermostat (8) on symbol (•) ; when the tempe-
rature increased the steam also increase until symbol max. (•••).
FABRIC
Do not iron
Synthetic, Nylon, Acryilic, Rayon
Wool, Silk
Cotton, Flax
: that means that the fabric must not be ironed.
17
to use steam function.
EN