Beper 50.933H Manuel D'instructions page 15

EN
Steam iron Use instructions
USE ADVICE
Make sure that the mains voltage corresponds to the data specified on the label.
Do not used the iron if the cord supply or plug are damaged or in case of electric shock
make it repaired by an authorized assistance centre.
When using the iron for the first time remove the protection on the soleplate.
When used for the first time the soleplate may diffuse a light smoke caused by evapora-
tion of protective oil used in factory ; that is not dangerous and smoke will disappear after
some use.
The iron may contain some residues into the tank ; when used for the first time the iron,
release the steam several times steam in order to eliminate the internal residues
Never pull the supply cord to unplug the appliance.
Do not roll up the electric cord around the iron.
Keep away to a reasonable distance the supply cord from the iron plate, especially when
it is hot.
When making a break or if not used, put the iron on the iron rest in vertical position.
Fill or empty the tank when the appliance is unplugged from the socket.
Do not fill the tank over his maximum capacity.
Do not fill with mixture stain-removing, vinegar, scaling or chemical agent, but use only
distilled or demineralised water.
The plate of the iron becomes very hot, take care not to burn yourself.
Never direct the jet of steam towards your face.
Always choose the right temperature according the cloth which has to be ironed.
Do not use the stream station as a heater. Do not iron the wet clothes, let them dry before
ironing.
Do not pass the iron on buttons or zipper in order to not to damage the plate.
Before cleaning, unplug the supply cord.
If you no longer use this appliance, please keep away from children.
15