Dovre 2180CBGD Installation Et Mode D'emploi page 51

Note: To fit the guiding system, follow the steps set
out above in the reverse order.
Adjusting the closure of the lifting
door
The position of the door relative to the front can be
adjusted. The guiding system should be freely
acessible. Remove the cover profiles or the frame, if
fitted.
1. Loosen the bolt on the side and adjust the door by
pressing it against the front. Tighten the nut; see
next figure.
Subject to change because of technical improvements
2. Press the door against the bottom of the front so
that the guide wheel just touches the closing
bracket; see next figure.
3. If necessary, adjust the position of the closing
bracket by loosening the three mounting screws
and moving the closing bracket. Tighten the
screws; see next figure.
21