Dovre 2180CBGD Installation Et Mode D'emploi page 39

The position of the damper can be adjusted.
1. Loosen the adjusting screw (A) as well a the bolt
(B); see next figure.
2. Turn the damper into the desired position relative
to the damper rod; see next figure.
Subject to change because of technical improvements
3. Tighten bolt (B) and then the adjusting screw (A) to
fasten the damper to the damper rod.
Changing the direction of the
connection collar
If you want to use a 45° connection instead of a
vertical connection, for example because it simplifies
connection to an existing flue gas duct, you have to
rotate the connection collar 180°; see the next figure.
9