Troubleshooting - Renkforce E-SA9M Notice D'emploi

Troubleshooting

In purchasing the miniature amplifier, you have acquired a product which uses the most up-to-date technology
available and is operationally reliable. Nevertheless, problems or faults may occur.
Therefore, we would like to describe here how to eliminate possible faults:
Always observe the safety instructions!
No sound is audible:
• A device in the playback chain is not turned on.
• The wrong input was selected on the amplifier.
• The volume control (16) is set to minimum.
• Fuse defective.
One channel does not function:
• A cinch cable was disconnected from the source device (e.g. the cassette recorder) or the cinch inputs (17-19).
• The balance control BALANCE (12) was set wrongly on the amplifier.
• A loudspeaker cable was disconnected from the loudspeaker clamp.
The sound is distorted:
• The amplifier input receives an excess signal.
• The volume is set too high and the loudspeakers distort.
• The controls BASS (13) or TREBLE (15) were set too high.
Playback is without bass:
• One loudspeakers is connected the wrong way.
• The bass control (13) on the amplifier is set to minimum.
40
Operating Instructions

English