Publicité
Les langues disponibles
Les langues disponibles
5.
FITTING
HOLDER
Take the bottle holder (18), insert it in
through the top of the handlebar (12),
Fig. 6.
Next, release the screws (17) on the
handlebar (12), position the bottle
holder and secure it by using the
screws (17) removed previously.
6.
INSTRUCTIONS
FITTING THE SADDLE
In order to raise or lower the saddle
post (39), figure 7, first loosen off the
control knob (41) on the saddle post a
little by turning it in an anticlockwise
direction.
Pull the control knob back and without
releasing it, move the saddle post up
or down. Next, take the horizontal tube
for the saddle (18) and attach the
saddle (33) to it, figure 7, tighten the
nuts (Z).
VERTICAL ADJUSTMENT.
In order to raise or lower the saddle
post, first loosen off the control knob
(41) on the saddle post a little by
turning it in an anticlockwise direction,
pull the control knob back and without
releasing it, move the saddle post up
or down, figure 7. When it is at the
right height release the knob and it will
lock into a hole on the saddle post.
Tighten it up by turning the control
knob (41) in a clockwise direction.
HORIZONTAL ADJUSTMENT.
To adjust the saddle's horizontal
position, loosen the control knob (37)
on the saddle's horizontal bar and
move the saddle, along with the bar,
into the desired position, then tighten
the control knob securely, figure 7.
THE
BOTTLE
FOR
TILTING THE SADDLE.
The saddle can be tilted backward or
forward. Loosen off nut (Z) shown in
figure 7, located under the saddle, tilt
the saddle into the desired position
and then retighten the nut securely.
Do not adjust the tilt of the saddle
while you are still sitting on it.
7 FITTING THE HANDLEBAR.-
Line the handlebar (4) up with the
lower holes on the main post (12),
passing the hand-grip cables through
the inside of the holder in the direction
indicated by the arrow, as shown in
Fig.8, and pulling them out through the
upper hole of the post. Next, take
screw (6) and flat washer (7) (8),
loosened previously and screw them
onto the bottom of the handlebar (4).
8. FITTING THE MONITOR
Release screws (3), Fig.8, at the back
of the monitor.
Next, slide the front of the monitor
onto the plate (5) in the direction of the
arrow, Fig.8, push the cables down
into the main post making sure not the
pinch any of the cables.
Replace the screws (3) removed
previously.
Bring the monitor (2) to the handlebar
stem (12) figure 8, connect the two
terminals coming out of the handlebar
stem (12) and the monitor (2), figure 8.
Insert
the
handlebar stem (12), as shown in
figure 8, making sure not to pinch any
of the cables. Fit the bolts (6) along
with the flat washers, making sure that
the handlebar is aligned correctly,
securely tighten all of the bolts on the
handlebar stem including the bolts at
the base which were left hand tight in
point 4.
13
monitor
(2)
onto
the
Publicité
