SOUNDMASTER DAB700WE Mode D'emploi page 15

CONTENT OF DELIVERY
 Main unit
 Instruction Manual
POWER SUPPLY
 Ensure that the voltage is the same as that indicated on the ac adapter identification plate.
 Connect the supplied AC adapter to a properly installed safety power socket and the plug of
the cable into the DC IN jack at the back side of the unit.
BATTERY OPERATION
1. Open the lid of the battery compartment at the bottom of the unit.
2. Insert 5 batteries of type LR14 ("C" size) 1.5 V. Please ensure that the polarity is correct (see
indicated in the battery compartment).
3. Then close the battery lid.
Note:
 When the unit is only powered by batteries, power on the unit and the battery symbol will
show on the display.
 When the batteries are low power , the battery symbol will flash and the sound of the
unit will distortion due to the low power. Please change the batteries in time
 When the unit is powered by the batteries, there will be no memory function after
power off the unit.
 When the unit is powered by batteries, in order to play longer time, it is better not
adjust the volume to max .
ERP power management
The unit will turn off automatically after 30 minutes in standby mode if there is no audio
signal. To turn on the unit again press the "ST/BY / MODE" button.
POWER ON / OFF
Press "ST/BY / MODE" button to turn the unit on.
Press and hold "ST/BY / MODE" button to turn off the unit in standby mode.
SELECTING MODES
During playing mode, press the "ST/BY / MODE" button repeatedly to switch between the modes.
ADJUSTING VOLUME
Press the "VOLUME –" or "VOLUME +" button to decrease or increase the volume.
MUTE
During playing mode, press the "PLAY/PAUSE/MUTE/SCAN" button, the sound will not be
heard from the speaker.
Press the "PLAY/PAUSE/MUTE/SCAN " button again or the "VOLUME –" or "VOLUME
+" button to cancel the mute function. The sound can be heard from the speakers again .
INSTALLATION

AC Adapter
BASIC OPERATIONS
2
DAB700 / English Instruction Manual