Publicité
Les langues disponibles
Les langues disponibles
5.6 Fitting the battery (Fig. 12/13)
Press the side pushlock button (15) of the battery
pack as shown in Fig. 12 and push the battery
pack into the mount provided. When the battery
is positioned as in Fig. 13, make sure that the
pushlock button latches in place! To remove the
battery pack, proceed in reverse order.
6. Operation
6.1 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.2 Battery capacity indicator (Fig. 14)
Press the battery capacity indicator switch (8).
The battery capacity indicator (7) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
To obtain maximum performance from your grass
trimmer, please follow these instructions:
•
Never use the grass trimmer without the
guard.
•
Do not mow grass when it is wet. The best
results are achieved with dry grass.
•
To switch on your grass trimmer, press the
On/Off switch (Fig. 13 / Item 1).
•
To switch off your grass trimmer, let go of the
On/Off switch again (Fig. 13 / Item 1).
•
Do not allow the grass trimmer near the grass
until the switch is pressed, i.e. the grass
trimmer is in operation.
•
To cut properly, swing the machine sideways
while moving forwards. Keep the grass
trimmer inclined at an angle of approx. 30°
while you do so (see Figs. 15 and 16).
•
If the grass is long, the grass must be cut
shorter in stages, starting from the tip (see
Anl_GC_CT_18_24_Li_P_SPK7_USA.indb 12
Anl_GC_CT_18_24_Li_P_SPK7_USA.indb 12
EN
Fig. 17).
•
Use the guard hood to prevent unnecessary
wear.
•
To avoid unnecessary wear, keep the grass
trimmer away from hard objects.
7. Cleaning, maintenance and
ordering spare parts
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
•
Use a brush to remove deposits from the
safety guard.
7.2 Changing the blade
IMPORTANT! Be sure to remove the battery
pack before replacing!
•
To remove the blade, push the blade inwards
and remove it through the larger opening as
shown in Fig. 11.
•
To fit the new blade, proceed in reverse order
(Fig. 10). Make sure that it clicks into place.
7.3 Maintenance
There are no other parts inside the equipment
which require maintenance.
- 12 -
05.08.2019 13:36:47
05.08.2019 13:36:47
Publicité
