Publicité
Les langues disponibles
Les langues disponibles
The motor of the
machine makes purring
and does not rotate.
The switch does not lock
on (after plugging to the
power and pressing the
switch, the saw stops
immediately)
Saw blade gets loose
after turning off the
motor
Periodic checking
After each use: clean thoroughly the machine.
Every 50 hours of operation: Check all screws & bolts connections, tighten if necessary.
6.4- Storage
- Keep the product, the instructions manual and all accessories in the original packaging (if possible).
- Before storage:
Allow the machine to cool down
Wipe the log saw clean with a brush. Apply a thin layer of oil using an oily cloth to protect the
machine from rust.
- It is recommended to store the tool in a dry & clean location out of children's reach.
- Cover the saw properly if you store it in a shelter or in poorly protected room.
- Protect the motor and especially the switch against water and moisture.
- Do not store anything above or on the log saw.
6.5- Disposal
- Do not dispose the product with household garbage. Do not throw into the environment.
- Dispose of the product in a collection centre for waste of electrical and electronic equipment, or a
waste drop-off centre; or seek advice from your local municipality.
- Disposal of the product, accessories and packaging should be carried out according to local
regulations governing environment protection.
Our warranty conditions are available from our STAV department [*] and on our website.
Should you have any repair requests under the warranty, please contact your retailer or our STAV [*]
who will inform you on the procedure.
Should you have any parts and/or accessories request, you can contact our STAV [*] to ask for the
product exploded view by indicating our reference and the serial number or batch number appearing
on the nameplate.
[*] STAV = Technical and After-Sales Service department
STAV contact details:
Tel : 08 92 35 05 77 (0,34€/min ; only in France) ; email :
Internet Website:
www.ribimex.com
Check the fuses
The neutral wire is missing on
the network side.
Fastening nut tightened
insufficiently
Ribimex, 56 Route de Paris, F-77340 Pontault-Combault.
Change fuses (if damaged)
Proceed with repair by qualified
technician (electrician)
Warning: locking a switch to be able to
work without neutral wire will damage
the switch and will void the warranty.
Tighten fastening nut, M20 left-handed
thread
sav@ribimex.fr
Page 41 of 43
Publicité
