Publicité
Les langues disponibles
Les langues disponibles
High Altitude
At altitudes over 5,000 feet (1524 meters), a minimum 85
octane / 85 AKI (89 RON) gasoline is acceptable. To remain
emissions compliant, high altitude adjustment is required.
Operation without this adjustment will cause decreased
performance, increased fuel consumption, and increased
emissions. See a qualified Sears dealer for high altitude
adjustment information. Operation of the engine at altitudes
below 2,500 feet (762 meters) with the high altitude kit is not
recommended.
Connect Hose and Water Supply to Pump
NOTICE
DO NOT run the pump without the water supply connected
and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Remove and discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1. Uncoil high pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER connect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Always be certain spray gun, nozzles and accessories are
correctly attached.
2. Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
All manuals and user guides at all-guides.com
3.
4. Run water through garden hose for 30 seconds to flush
IMPORTANT: DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
5. Connect garden hose (not to exceed 50 feet in length) to
Using a One Way Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
• There MUST be at least ten feet of unrestricted garden hose
• Damage to equipment resulting from failure to follow this
6. Turn ON water, point gun in a safe direction and squeeze
• Always wear safety goggles when using this equipment or in
• Before starting the pressure washer, be sure you are wearing
• NEVER substitute safety glasses for safety goggles.
CHECKLIST BEFORE STARTING ENGINE
Review the unit to ensure you have performed all of the
following:
1. Be sure to read Safety Rules and Operation sections
2. Make sure handle is in place and secure.
3. Check that oil has been added to proper level in engine
4. Add proper fuel to fuel tank.
5. Check for proper hose connections (high pressure and
6. Provide proper water supply (not to exceed 100°F).
9
Before connecting garden hose to water inlet, inspect
inlet screen (A). Clean screen if it contains debris or have
it replaced if damaged. DO NOT run pressure washer if
inlet screen is damaged or missing.
it of debris. Turn off water.
water inlet. Tighten by hand.
NOTICE
between the pressure washer inlet and any device, such as a
vacuum breaker or check valve.
instruction will void warranty.
trigger to purge pump system of air and impurities.
WARNING
Risk of eye injury.
Spray can splash back or propel objects.
vicinity of where equipment is in use.
adequate safety goggles.
before using the pressure washer.
crankcase.
water supply) and that there are no kinks, cuts, or
damage to the high pressure hose.
A
Publicité
